Right Front Suspension Refurbished - ATE parts from '81

Koni shocks and Centerline springs

Drivers Side Front Suspension 2

Drivers Side Front Suspension 3

Trunion Bushing extracting

Pressing Rear arm bushing

Upper Mount Plate - Rear anti-sway

Cut from 1981's bodywork - inserted here to receive upper bolt, one per side. Lower mount bolt is seen below. Need to be welded in.

Steering Idler Box ready to assemble

Steering Idler Box Assembled - needs cap

Steering Idler Box Installed

These were spray painted , not powder coated. New ball Joints.

From 1981 spider. Powder coated, new end bushings. Re-used main rubber busingins as they were fine. Mounts up into nuts welded in abiove. Note fuel pump. This unti was discarded and replaced with a Carter unit.

Left front suspension w/steering rack

Right front suspension w/steering rack

Trunion Silent Block assembly

P1090028

Powder Coated and assembled Trunion.JPG

Trunion Installed w/ new bushings.JPG

Rear Axle - Dominics/bearings, AlfaImportCenter/differential

Right Rear suspension

Left Rear Suspension

Rear axle from Right side

Powdercoated driveshaft and new u-joints

Rear driveshaft body from '81 (9mm) & slip yoke from 67 (8mm)

Stainless Steel brake & fuel pipe, new handbrake cable

P4050045.JPG

Right rear brake & axle

P4050047.JPG